SPECIFICATIONS:
HARDWARE FEATURES:
• CPU 8086 with 6. 144MHz crystal working in maximum/minimum mode.
• Memory: 32K EPROM : 32K RAM
• Keys: 24 Software programmable keys.
• Display: 7 numbers of high bright 7 segment displays for Data and address.
• I/O port: One 8255 programmable peripheral interface port
• Software: Enter, Alter, Increment! Decrement address, Move, Fill, POS etc.
• Built-in Power supply
• Memory: 16 KB Monitor ROM organized as 8KB x 2 ROM 16 KB RAM organized as8KB x 2 RAM
• 50 pin flat cable termination for 24 parallel port lines using 8255
SOFTWARE FEATURES:
• Program Entry
• Address field is 5 digits wide for the 20-bit address of 8086.
• Address set and verifies ROM locations, verify / alter the contents of RAM locations Automatic address set to start of RAM at 00400h
• Data is set / altered in memory immediately for each hex key entry.
• Increment/ decrement the address and display / alter the contents.
PROGRAM EXECUTION:
• Program could be executed from the current user CS: IP contents.
• Set a new CS: IP value through GO key. The code segment and instruction pointer values are automatically decoded by the system from the 5 digit
• address .
• Single step execution in RAM / ROM.
• Break set facility. The break set could be cleared only through break clear function, Break clear.
• Facility for register display / alter the contents in REG mode or in STEP/execution with break
PROGRAM EDITING:
• Move a block of data.
• Fill a block of RAM with constant data.
FEATURES:
• 6K Bytes of EPROM with 16K bytes of Battery Backup RAM
• 72 I/O Lines, Three Channel Timer/Counter, PC Serial Interface using USART, Interrupt Controller
• Seven Segment Display with 28 Keys Hex Keypad
• Power-full Command like Single Stepping, Break Point, Full Clock Execution, Examine Memory/ Register
• 16K bytes of RAM using two nos. of 6264 with Battery Backup expandable up to 256KB)
• Three 16-bit programmable 8253/8254
• Two modes of operation
• Powerful Commands like Examine/Edit Memory, Examine/Edit Register, Single stepping, Execution, Block Move can be used through hex keyboard or PC serial mode
• 72 I/O lines through 3 nos. of 8255 brought at 26 Pins FRC Connector to interface with IC-XX Series
• RS-232C interface using 8251 brought out at 9 Pins DType Connector. On-board Interrupt controller using 8259 brought out at 20 Pins FRC Connector
• 16 bit Timer/Counter through 8253 brought out at 20 Pins FRC Connector
• User’s Manual with sample programs
• All ICS are mounted on IC Sockets
• User Guide: -HW/SW Battery Operation.
ACCESSORIES:
• 2mm multi coloured moulded patch cords with daisying facility.
