VOLTAGE STANDING WAVE RATIO METER (Specification):
It is a high gain voltage amplifier tuned at the center frequency of 1KHz. It is used for measuring VSWR, Attenuation and total mismatch on the line.
Amplifier Type
High gain tuned at one frequency.
Frequency
1000 Hz.
Sensitivity
0.1 Micro volt at 200 ohms for full scale.
Band Width
25 to 30Hz
Range
60 db min. in 10 db scale.
Accuracy
0.15db on one range
Meter Linearity
1% of full scale
Scale- Selector
Normal, Expander
Gain Control
Coarse & fine
Input
BNC (F), 2000 ohms impedance
Input Selector
Crystal, ( 4.5mA ) and high ( 8.75mA )
Mains Power
230 V AC, 50Hz
EXPERIMENT FOR GUNN OSCILLATOR:
• To study of I-V Characteristics of Gunn Oscillator & pin modulator.
• To determine the frequency and wavelength in a rectangular waveguide working TE10 mode.
• To determine the standing wave ratio and reflection co-efficient.
• To measure an unknown Impedance using the smith chart.
• To measure the polar pattern and the gain of a wave guide Horn antenna.
• To study the function of multi-hole directional coupler by measuring the following parameters. Mainline and auxiliary-line VSWR.
• The coupling factor and directivity of the coupler.
• Study of Magic Tee.
• To study the Isolator and circulators.
• To study the attenuator.
• To study the dielectric constant measurement
• To calibrate phase shifter.
Power
It is operated on 230VAC/50Hz.
Housing
It is housed in an elegant metal cabinet (CNC Machine Finish)
Accessories
Cables, Screw’s & Nuts.
Instruction Manual
Trainer comes with detailed instruction manual.
MEASURING INSTRUMENTS REQUIRED (*Not Supplied):
• 30MHz Dual Oscilloscope.
• Digital Multimeter.
MICROWAVE TRAINING SYSTEM(GUNN DIODE )MWT1
GUNN POWER SUPPLY (Specification):
Gunn power supply comprises of an electronically regulated power supply and generator designed to operate the gunn oscillator and pin modulator.
Gunn bias voltage | .5 to 12V |
Current | 0 to 1.5 A ( Max.) |
Regulation | 10% Mains0.2% for |
Ripple | 2 mV (r ms) |
Type of modulation | Internal as well as by using pin modulator |
Modulation Frequency | 900 to 1100 Hz Square wave |
Modulation Amplitude | 0 to 15V (Peak to Peak) |
Output Connector | BNC (F) for both gunn bias and pin modulator |
Mains | 230VAC, 50Hz, 115 Watt approx. |
Categories Microwave Training System, Products
Share this product
Share on facebook
Share on twitter
Share on linkedin
Share on pinterest
Share on whatsapp
Share this product
Share on facebook
Facebook
Share on twitter
Twitter
Share on linkedin
LinkedIn
Share on pinterest
Pinterest
Share on whatsapp
WhatsApp